Setup Key - Ametek Thermox Series 2000 WDG-IV User Manual

Setup Key

4-4 | Thermox Series 2000 WDG-IV / IVC / IVCM
Display
Process Pressure
System Tests
Sensor COnfig
Figure 4-2. Setup Key menu options.
SETUP KEY
Menu Options
Display Define what information to place on each display line.
Passwords Create a system password to limit control unit access.
Process Select a positive or negative process pressure.
Pressure Enter process pressure value.
System Tests Perform internal diagnostics on Series 2000.
System Serial # View serial and manufacturing number for the control unit.
Primary
Perform an automatic, remote, or manual primary calibration
Calib
This is not a typical calibration. A primary calibration is intended to extend the life
of your sensor. Do not perform this type of calibration unless specifically instruct-
ed to do so.
Sensor Config Select the type of sensor you are using.
Communication Define Series 2000 communication parameters.
Combustibles Define combustibles scale (% or PPM).
Define combustible detector type.
This only applies if you purchased a combustibles detector.
SETUP KEY
Passwords
System Serial #
Primary Calib
Communication
Combustibles
Functions/Options