Communication; Combustibles Option - Ametek Thermox Series 2000 WDG-IV User Manual

Communication

Define RS-485 communications parameters between the Series 2000 con-
trol unit and a host device. This includes the following:
Allows you to define the baud rate that the control unit and the
Baud Rate
host computer are using to communicate. Choices are 300,
600, 1200, 2400, 4800, and 9600 baud.
Allows you to define the physical address for the control unit
Node Address
(between 0 and 255) on a network so the host computer can
identify the control unit if using network communications (see
below). Note that each control unit must be assigned a unique
address; otherwise, communication results will be unpredict-
able.
Allows you to temporarily disable control unit serial communi-
Enable Serial
cations.

Combustibles Option

Combustibles Choices are % combustibles or PPM combustibles.
Scale
The % combustibles full scale range is 0 to 5 %.
The PPM combustibles full scale range is 0 - 10,000 PPM.
If you have the methane option, the range is always in % methane (not select-
able), and the full scale range is 0 to 5 %.
If you have a methane detector, the combustibles detector must be used in the
PPM range.
Combustibles Choices are Hot Wire and RTD detector.
Type
If not sure, check your customer configuration sheet, in-
cluded in the front of this manual.
Controller / User Interface | 4-13