Ametek Thermox Series 2000 WDG-IV User Manual page 78

• If you select to display Combustibles, the display will show % com-
• If you select Methane, the display will always show % methane.
4-6 | Thermox Series 2000 WDG-IV / IVC / IVCM
Use the following keys to move directly to a specific location in the ASCII
text table:
Press this Key
Combustibles and methane scale shown on display
bustibles or PPM combustibles, depending on what you selected for
the Combustibles Option from the Setup key.
Option
% combustibles
PPM combustibles
methane
An incorrect combustibles reading is always displayed after the initial

installation (the information on the combustibles display line wraps
around to the display line below and over-rides a few characters).
NOTE
Even though the unit was calibrated at the factory, the analyzer must
be calibrated again after installation. Once the analyzer is calibrated
and the combustibles signal is in the normal range, the display lines
will show the correct reading.
Move to this Location
1 capital letter A.
3 capital letter Z.
7 small letter a.
9 small letter z.
5 space character.
0 number zero character.
Full Scale Range
0 to 5 %
0 - 10,000 PPM
0 to 5 %