Ametek Thermox Series 2000 WDG-IV User Manual page 184

CALIBRATE KEY
Menu Options
Initiate Cal/Initiate Verify
Cal/Verify Data
cal gas Values
Inject Cal Gas
set cal Timers
(applies only for auto cal operations with
Rcu, except for setting time and date)
set K Factor (not used on wDg-IV series)
Sensitivity
Table B-5. Calibrate Key menu.
Functions/Options
start an automatic, remote, or manual calibration
or verify
View latest calibration and verify data.
- cal data
- Verify data
Enter calibration gas values.
Set pressure and flow to RCU gases without
performing a calibration.
set control unit time/date.
Enable or disable auto cal cycles.
Set cal gas times for auto cal/verify operations.
Define recovery durations after a cal/verify.
Enter Value
View the Sensitivity (Slope) determined dur-
ing calibration for the combustibles detector in
mV/1000 PPM.
Menu Option Charts | B-3