Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
Setting up Cue Tones
1
From the user interface of the D9859, choose Audio & Video > Cue Tone. The
Cue Tone page is displayed.
2
The Sequence Number lists the tone sequences. The transcoder supports up to
16 tone sequences. You can configure the state, tones, mode, and delay for each
tone sequence.
3
From the Sequence State drop-down list, choose to enable or disable the current
tone sequence. When disabled, no cue tone is output.
4
In the Sequence Tones field, set the three digit tone sequence (1 to 999).
5
From the Sequence Mode drop-down list, choose the tone sequence mode.
Select * for start tone, # for the end tone, and */# for the start and end tones. The
end tone is signaled after waiting the time specified in the Sequence Delay field.
6
If the Sequence Mode is set to */# (Start/Stop), set the sequence delay in the
Sequence Delay field, in seconds, between the start and stop sequences. You can
enter a value in the range from 1 to 255. The default is 30.
7
Click Apply.
180
OL-31980-01
Hide quick links:
Advertisement
Table of Contents
