The Program Entry - Referenced PIDs table displays the specified PE ES PIDs
information on the output.
The Output Channel and PID Conflicts table displays a list of conflicts when the
DPM alarm is active.
Configuring the MPEGoIP Output
1
From the user interface of the D9859, choose Transport Stream > MPEG over IP
Output. The MPEG over IP Output page is displayed.
Note: Any changes made to the MOIP DPM values will automatically change the
Mode Status to Edited by User.
2
From the Rate Control drop-down list, choose the DPM output rate control. The
following table describes the affect each of the settings has on the output bit rate:
OL-31980 -01
Configuring Transport Stream Information
195