Chapter 5 Web GUI Setup and Monitoring
11 Click OK.
12 Click Apply.
13 Click Copy To ASI to copy all the DPM data from the MPEG over IP output to
the ASI output.
Viewing the MPEG Output Transport Status
From the user interface of the D9859, choose Transport Stream > Output Transport
Status under MPEG over IP Output. The PID Output Status page is displayed.
The Program Entry - Referenced PIDs table displays the specified PE ES PIDs
information on the output.
The Output Channel and PID Conflicts table displays a list of conflicts when the
DPM alarm is active.
Typical set up for Digital Program Mapping (DPM)
1
Verify that you are receiving a valid signal and that you have set up the channels
that you want to pass, drop, or map.
2
From the user interface of the D9859, choose Transport Stream > ASI Output or
MPEG over IP Output.
3
From the Output Mode drop-down list, choose Full DPM Control.
210
OL-31980-01