Cisco D9859 Installation And Configuration Manual page 102

Chapter 4 Front Panel Operation
Menu Item
Act Conv
WSS Mode
WSS Status
78
Description
The actual aspect ratio conversion the
receiver will perform based on what you
have selected. This is read-only.
Refer to the Aspect Ratio Conversions
table below for the conversions performed
by the receiver based on your selection,
and the effect on the picture displayed by
the receiver in each case (without Auto
AFD)
Select the Wide Screen Signaling output
mode. It is used to select how the receiver
affects PAL WSS when it is present in the
VBI line 23.
This indicates the current output value of
PAL WSS in VBI line 23.
Parameters
None, 16:9 L/B, 4:3 P/B, 14:9,
4:3 CCO, 16:9 SCALE
Auto:Create - Creates WSS to
output the correct aspect ratio
when performing aspect ratio
conversion.
Auto:Modify - If WSS is present
in the input stream, it is
modified to output the correct
aspect ratio when performing
aspect ratio conversion. If WSS
is not present in the input, no
WSS will be present in the
output.
Suppress - Removes WSS
output.
Passthrough - Passes WSS
unmodified as received by the
receiver.
The default is Passthrough.
4:3 F/F, 16:9 L/B CEN, 16:9
L/B TOP, >16:9 L/B, 14:9 L/B
CEN, 14:9 L/B TOP, 14:9 F/F
CEN, 16:9 F/F, or UNDEFINED
Note: F/F is full format, and
L/B is letter box.
OL-31980-01