Cisco D9859 Installation And Configuration Manual page 337

Warning Message
Type
Hardware Set
Platform
Hardware Clear
Platform
Xcode Video Buf Set
Oflw
Xcode Video Buf Clear
Oflw
Xcode Delay Buf Set
Oflw
Xcode Delay Buf Clear
Oflw
OL-31980 -01
Message Cause/Remedy
Non-matching Cause: Non-matching
HW Platform. App was loaded
APP: <D9859 | through either CDT
D9854/58/24>, download or FLASH
HW: <TMB2 |
programming.
HDR/TMB/HDR
Remedy: Replace the
2>
non-matching App and
then reboot the IRD.
Matching –
Hardware
Platform
detected.
PE(s): x;y;z Cause: Video buffer
overflow reported when
the transcoding chip
outputs more data that
the path is capable of
handling. The limitation
is a combined bit rate of
all transcoding paths
and all delayed paths,
and it is when this
combined bit rate is
above 203.04Mbps.
Remedy: Verify that the
configured overall bit
rate for 8 transcoders
does not exceed the
FPGA path limitation.
Fault cleared –
PE(s): x;y;z Cause: Delay path buffer
overflow reported when
the transcoding chip
outputs more data than
the path is capable of
handling.
Remedy: Verify that the
configured overall bit
rate for 8 transcoders
does not exceed the
FPGA path limitation.
Fault cleared –
Description
D9859 App running
on D9854/58/24
platform or vice versa.
–
Transcoder board
FPGA reports buffer
overflow on video PID
path.
–
Transcoder board
FPGA reports buffer
overflow on delayed
PID path.
–
ID
94000
94000
94004
94004
94006
94006
313