Cisco D9859 Installation And Configuration Manual page 120

Chapter 4 Front Panel Operation
Menu Item
Config Type
Insert Null Packet
Descramble Mode
Auto Map
96
Description
Indicates the current DPM
configuration change by a user
after changing the Output
Mode.
This parameter selects whether
to insert null packets in the
output stream.
Null packets are always
inserted if the Rate Control is
set to User.
This parameter selects whether
the receiver should scramble
the output even if it is
authorized to receive the
channel.
Sets whether the DPM resolves
the channel and PID collisions
automatically on the transport
outputs. New values are
assigned to the parameters that
caused the conflict. The new
assigned values are not used by
any incoming transport or other
PE outputs. If a collision is
detected, you can review the
new changes before applying
the new changes.
Parameters
Edited by User - DPM changes were made.
Unmodified - No changes were made after
setting a new Output Mode.
Auto Re-Mapped - Output map changed
automatically to fix the output channel or PID
conflicts at the time of setup.
Changed by Uplink - DPM output changes
were initiated by an encoder.
Yes or No
The default mode is Descrambled.
Scrambled - Scrambles the output channel
even if the PE is authorized and can
descramble the channel.
Descrambled - Descrambles the output
channel, and passes in-the-clear channels.
Yes or No
OL-31980-01