Setting Up The Asi Input - Cisco D9859 Installation And Configuration Manual

Chapter 5 Web GUI Setup and Monitoring

Setting up the ASI Input

1 From the user interface of the D9859, choose Input > Input Setup. The Input
Setup page is displayed.
2 Click ASI.
3 Check the Use ASI Input check box to tune to the ASI input.
Note: Setting a new input to be active will deactivate the currently active input.
4 Click Apply.
Viewing the ASI Input Status
The ASI Input Status table displays the current ASI status. The following table
describes the ASI Input Status information displayed:
Parameter
Active Input
Signal Status
Input Rate (Mbps)
146
Description
Indicates the currently selected input source (RF1, RF2, RF3,
RF4, or ASI).
Indicates whether the input signal is locked.
Locked - Indicates the transcoder is locked to a carrier

with no valid content.
Lock+Sig - Indicates the transcoder is locked to a

carrier with valid content.
No Lock - Indicates the transcoder is not locked to a

carrier.
Displays the bit rate of the input transport stream, in Mbps.
OL-31980-01