Cisco D9859 Installation And Configuration Manual page 232

Chapter 5 Web GUI Setup and Monitoring
3 From the Duplication Method drop-down list, choose the duplication method of
the DPM program, which modifies the PSI to duplicate a program and its
content. This parameter is only used if Remapping Mode is set to Svc ID & PI D.
The following table describes the each duplication method:
Duplic Mode
PSI Remap
Pkt Copy
Pkt Copy is recommended for most applications.
4 Select the DPM action to use for Unreferenced Content. Unreferenced content is
the remainder of the transport that is not filtered by the program entries. Select
Drop (default) to drop all unreferenced content. Select Pass t o pass all
unreferenced content to the output unchanged.
5 From the Service ID Output drop-down list, choose whether the transcoder
should always generate PSI tables for the Mapped PE even if the selected input
channel is not available, or for only valid service channels/IDs. The following
table describes each service ID:
Svc ID
Valid Ch
All Ch
6 From the SI Regeneration Option drop-down list, choose the SI regeneration
option that applies the PowerVu rates (consistent with the uplink). This
parameter is only used if Remapping Control is set to None. The following table
describes each PSI rate:
PSI Rate
Auto
MPEG Min
SA Std
208
Description
Every input PID can be mapped to one output PID. If PID
mapping conflicts exist, DPM will use the Precedence Rule to
decide which output PID to use. All PMTs using the input PID
will be updated to reference the output PID specified by the
winner.
An input PID can be mapped to multiple output PIDs. The PID
will be duplicated as many times as needed (up to a certain
hardware limitation).
Description
Only transmits the PSI tables for the mapped program if the
program exists on the input stream.
Transmits the PSI tables for the mapped program even if the
program does not exist in the input stream.
All Ch is only valid if the PAT, NIT, SDT and PMT are set to
Regenerate.
Description
Matches the generated PSI tables' output rate as the incoming rate.
Transmits the generated PSI tables on the longest intervals that are
allowed by MPEG standard.
Transmits the generated PSI tables based on PowerVu standard
intervals.
OL-31980-01