Table of Contents
Advertisement
If you choose Custom, click Configure Custom SI Recv and the Configure
Custom SI Recv window opens.
3
From the Frequency Tuning Mode drop-down list, choose the frequency tuning
mode that determines whether to use the NIT to tune to other transports, or to
force the tuning to user configuration settings. Select NIT and the receiver can
change tuning parameters to use all transports available in the NIT. Select User
Cfg to force the receiver to use the user selected tuning parameters.
4
The Service List mode determines which tables are required for tuning.
Rigorous requires all service list tables to be present to acquire the signal.
Degraded requires any service list table to be present to acquire the signal.
5
From the Bouquet Association Table drop-down list, choose Yes to use the NIT
when creating the service list. If set to No, it is view-only. It is not supported in
the current release.
6
From the Network Information Table (NIT) drop-down list, choose Yes to use
the NIT when creating the service list.
7
From the Service Description Table (SDT) drop-down list, choose Yes to use the
SDT when creating the service list.
8
From the Program Association Table (PAT) drop-down list, choose Yes to use
the PAT when creating the service list.
9
Click OK.
10 Enter the Network ID of the uplink signal the receiver is to receive when using
the selected preset. The transcoder's network ID must match the network ID
associated with the transmitted signal that identifies the NIT to be used. You can
enter a value in the range from 1 to 65535. The default is 1.
11 From the CA Mode drop-down list, choose which programs can be viewed via
the transcoder. Choose Std (standard) for PowerVu signal or Open conditional
access for free-to-air (that is, in-the-clear signals). The default is Std.
12 Click Apply.
OL-31980 -01
Setting up Input Information
149
Hide quick links:
Advertisement
Table of Contents
