Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
Stream Details
Stream
Bitrate (Mbps)
Encapsulation
Destination IP
Destination UDP
Port
2
To modify the stream information, select the stream and click Edit.
3
Make the necessary changes and click Save.
4
To configure MPTS advanced settings, select the stream and click Advanced.
The following table describes the MPTS advanced settings:
Advanced Settings
Traffic Class
Time to Live (Max #hops)
Source UDP Port
Announce Type
Announce Title Source
Announce User's Title
5
Click OK.
202
Description
Type of stream (MPTS).
This is the bit rate of the stream, in Mbps.
Selects the transport protocol to use for the output stream (UDP or
RTP).
Enter the unicast (valid host IP only) or multicast destination IP
address.
This selects the destination port number (1 to 65534).
Note: If you selected RTP for Encapsulation, you must select an
even destination port number.
Description
Sets the quality of service (0 to 255).
This sets the hop limit of the packet's lifespan (0 to 255).
This sets the source UDP port number (0 to 65535).
Note: Set the Source UDP Port to 0 to use the default UDP
port (49162).
Select RFC 2327 to send the Session Announcement Protocol
(SAP) messages according to the RFC 2327 standard.
Otherwise, select None to not send SAP messages.
Select User String to use the SAP string as the channel name,
defined in the Announce User's Title below. Otherwise, select
SDT channel to use the SDT string as the channel name.
If User String is selected as the Announce Title Source, enter
the SAP identifier (ID)/string, up to 31 characters.
OL-31980-01
Hide quick links:
Advertisement
Table of Contents
