Cisco D9859 Installation And Configuration Manual page 217

6 If PSI Table Output Option is set to Ctrl by Table, select the regeneration rate for
those PSI tables being regenerated in the SI Regeneration Option drop-down
menu. This parameter is only used if Remapping Control is set to None. The
following table describes each PSI rate:
PSI Rate
Auto
MPEG Min
SA Std
7 From the PSI Table Output Option drop-down list, choose the action to perform
on the PSI tables for the output stream. The table below describes each option.
PSI Options
Pass All
Drop All
Ctl By Table
8 If Ctl By Table is selected as the PSI Table Output Option, click Table Options
to configure the DPM table options. The DPM Table Options (ASI) window is
displayed.
OL-31980 -01
Description
Matches the generated PSI tables' output rate to the incoming rate.
Transmits the generated PSI tables on the longest intervals that are
allowed by MPEG standard.
Transmits the generated PSI tables based on PowerVu standard
intervals.
Description
Transmits the incoming PSI Tables as is; does not modify the
content and rate. The SI Regeneration Option and table settings are
ignored.
Does not transmit any PSI Tables. The SI Regeneration Option and
table settings are ignored.
The operator can click Table Options to select the table specific
output mode for each table.
Configuring Transport Stream Information
193