Cisco D9859 Installation And Configuration Manual page 118

Chapter 4 Front Panel Operation
MOIP
Menu Item
Name
Rate Control
94
Description
This is the name assigned to the
transport output for ease of
reference.
This is the DPM output rate
control.
Parameters
20-character string
Auto - The output rate follows that set by the
uplink. This setting can be used if the signal
source is ASI. If Insert Null Packet is set to
Yes, the output bit rate is the same as the input
rate (including all the null packets). If Insert
Null Packet is set to No, the output rate is
equal to the payload rate of the transport
stream to be encapsulated, and in most cases,
it will be lower than the overall input rate.
User - The output rate is specified by the User
Rate parameter. It is determined by the user
setting regardless of the input source. Null
packets are always inserted when the
configured output bit rate is higher than the
payload rate of the transport stream to be
encapsulated.
OL-31980-01