Cisco D9859 Installation And Configuration Manual page 338

Chapter 6 Service and Maintenance
Warning Message
Type
Xcode Delay Pkt Set
Drop
Xcode Delay Pkt Clear
Drop
Transcoder Set
Input
Transcoder Set
Input
Transcoder Set
Input
Transcoder Set
Input
314
Message Cause/Remedy
PE(s): x;y;z Cause: Possible
misconfiguration of
delay value. The packet
delay is caused by
arriving too early and it
cannot be held in the
buffer, or it arrived too
late on the delay path.
This is a software issue.
Fault cleared –
Unsupported Cause: Input stream
configuration is
Video Format
incorrect.
Remedy: Request a
compatible stream
format from your uplink
provider.
Unsupported Cause: Input stream
configuration is
Aspect Ratio
incorrect.
Remedy: Request a
compatible stream
format from your uplink
provider.
Unsupported Cause: Input stream
Video Profile or configuration is
level incorrect.
Remedy: Request a
compatible stream
format from your uplink
provider.
Input Underflow Cause: Possible
transcoder firmware
error.
Remedy: If problem
persists, contact Cisco
customer support.
Description
Transcoder board
FPGA reports packet
dropped on delayed
PID path.
–
Video format of one of
the channels is not
supported by this
decoder.
Video format of one of
the channels is not
supported by this
decoder.
Video format of one of
the channels is not
supported by this
decoder.
Internal transcoder
buffer overflow or
underflow. Errors will
be seen in the
transcoded output.
OL-31980-01
ID
94007
94007
94009
94009
94009
94009