Table of Contents
Advertisement
Chapter 5 Web GUI Setup and Monitoring
Setting up Cue Tones
1
From the user interface of the D9854/D9854-I, choose Audio & Video > Cueing
> Cue Tone. The Cue Tone page is displayed.
2
The Sequence Number lists the tone sequences. The receiver supports up to 16
tone sequences. You can configure the state, tones, mode, and delay for each tone
sequence.
3
Choose the Sequence State (Enabled or Disabled) of the current tone sequence.
When disabled, no cue tone is output.
4
In the Sequence Tones field, set the three digit tone sequence (1 to 999).
5
From the Sequence Mode drop-down list, choose the tone.
Choose * for start tone, # for the end tone, and */# for the start and end tones.
The end tone is signaled after waiting the time specified in Sequence Delay.
6
If the Sequence Mode was set to */# (Start/Stop), set the Sequence Delay, in
seconds, between the start and stop sequences. You can enter a value in the
range from 1 to 255. The default is 30.
7
Click Apply.
220
Advertisement
Table of Contents
