Cisco D9859 Installation And Configuration Manual page 129

Menu Item
Act
StTyp
OTyp
In
PID
PSI Table Settings
Note: The table settings are only available if you selected Ctl by Table in the PSI
Options menu. The default values for the PSI table settings are dependent on the
Output Mode. For a list of default values, see DPM Default Settings for Different
Output Modes (on page 351).
Setting
PAT
CAT
PMT
TSDT
NIT
OL-31980 -01
Description
Select the action to perform on
the current PID.
The Drop action is always
performed, but the Map option
is only applied if the PE action
is set to Map or XCode.
Enter the stream type to map
within a PE to a specified PID.
Select the service to configure.
If an input service matches this
type and instance specified by
In, then the Action will be
applied.
Select the instance of the service
specified by OType to
configure. If an input service
matches this type and instance,
then the Action will be applied.
If mapping this PID (Act is set
to Map), select the output PID
number.
Mode Options
Pass, Drop, Regen
Pass, Drop, Regen
Pass, Drop, Regen
Pass, Drop
Pass, Drop, Regen, PwRC Network Information Table
Parameters
Map - The service selected by the
OutType and Instance will be
mapped to the specified PID. This is
only applied if the PE action is set to
Map or XCode.
Drop - The service selected by the
OutType and Instance will be
removed from the PMT and the
output stream.
0 to 255
UNKN, ETV, CDT, LSDT, DATA,
TTX, MPE, DPI, VBI, SUBT, AUD,
VID, PCR or INVL
1 to 64
1 to 8190
Description
Program Association Table
Conditional Access Table
Program Map Table
Transport Stream Description
Table
Setup Menu
105