Cisco D9859 Installation And Configuration Manual page 121

Menu Item
Auto Map Aux
MOIP Streams
Menu Item
User Rate (Mbps)
Intf Mode
TS/IP
PCR@IP Start
OL-31980 -01
Description
Select whether the DPM sets the
output actions for all the
auxiliary PEs to Map when the
Output Mode is set to
Transcode. If the Fixed Output
is set to Yes, the output
configuration for the auxiliary
PEs is determined by the fixed
output table options when you
resynchronize the output
channels and PIDs to match the
input programs.
Note: The DPM resolves any
output conflicts automatically,
even if the Auto Map is set to
No.
Description
This parameter controls the
output rate when Rate Control
is set to User.
Note: Output data will be
partially or completely lost if
the user-selected bit rate is set
to a value that is less than the
actual signal bit rate.
This selects the MPEG over IP
output mode.
This selects the maximum
number of transport packets
per IP packet.
This selects whether to always
transmit a new IP packet when
a new Program Clock Reference
(PCR) arrives.
Parameters
Yes or No
Parameters
0 to 206 Mbps
None - Disables the MPEG over IP
interface.
Data Port - Always output data on the
Data port.
Control Port - Always output data on
the Management port.
1 to 7
Yes or No
Setup Menu
97