Cisco D9859 Installation And Configuration Manual page 115

TS Out - ASI
Menu Item
Name
Rate Control
User
Rate(Mbps)
OL-31980 -01
Description
Displays the name assigned to the
transport output for ease of
reference. This is read-only.
Select the output rate control.
If the Rate Control is set to User,
set the maximum output bit rate.
If null packets are inserted, this
will be the output rate.
This setting is used when the
signal source is RF or ASI and
allows you to set the output bit
rate to a value expected by
equipment connected to the ASI
output.
Parameters
20-character string
Auto - The output rate follows that set by the
uplink. This setting can be used if the signal
source is ASI. If Insert Null Packet is set to Yes,
the output bit rate is the same as the input rate
(including all the null packets). If Insert Null
Packet is set to No, the output rate is equal to the
payload rate of the transport stream to be
encapsulated, and in most cases, it will be lower
than the overall input rate.
User - The output rate is specified by the User
Rate(Mbps) parameter. It is determined by the
user setting regardless of the input source. Null
packets are always inserted when the configured
output bit rate is higher than the payload rate of
the transport stream to be encapsulated.
0 to 206 Mbps
Note: Output data may be lost if this bit rate is set
to a value less than the actual signal bit rate.
Setup Menu
91