Cisco D9859 Installation And Configuration Manual page 235

4 If necessary, select the Descrambled mode according to whether the program is
to be scrambled or descrambled for downstream viewing or monitoring.
5 Click Apply.
6 Choose Transport Stream > Digital Program Mapping for ASI Output or
MPEG over IP Output. The ASI or MPEGoIP Digital Program Mapping page is
displayed.
7 In the DPM Program Entry Setup, click Resynchronize All and select
Resynchronize Program, PMT PID, ES List & ES PIDs and click OK. This
copies the input services PIDs to the remapped output service PIDs.
8 In the DPM Program Entry Setup table, select the PE containing the channel you
want to configure and click Edit. The DPM PE PID MAP window is displayed.
9 From the Action drop-down list for an input stream, choose Drop or Map.
10 Configure the input to output channel mapping from the Category drop-down
list. Video and PCR can be output on the same PID or different PIDs. If output on
the same PID, they will appear identical to the input.
11 Click Save.
12 Click OK.
13 In the DPM General Settings section, set the following parameters:
Parameter
Remapping Mode
Duplication Method
Unreferenced Content
Service ID Output
PSI Table Output Option
PSI Regeneration Option
14 Click Table Options. The DPM Table Options (ASI) window is displayed.
15 Set the following parameters:
Parameter
PAT
CAT
PMT
TSDT
NIT
NITO
SDT
OL-31980 -01
Configuring Transport Stream Information
Description
Svc ID & PID
Pkt Copy
Drop
Valid Ch/All Ch
Ctl By Table
Always/As Needed
Description
Regen
Regen
Regen
Drop
Regen or Drop
Drop
Regen
211