Quick Setup Instructions for RF Acquisition
1
Press MENU to display the Main menu.
2
Press
menu. Press SELECT.
3
To setup the ASI input port, go to step 4. To setup the RF1 input port, go to step
5.
4
Press SELECT three times. Press
SELECT. Go to step 11.
Press SELECT. Press to go to RF1. Press SELECT twice. Use
5
port parameter to Act (Activate). Press SELECT.
Press to move to the LO1, LO2, Crossover menu. Verify these parameters for
6
your application. If no change is needed, go to Step 7. If required, you may
modify these settings. Use to move to the parameter that you want to modify.
Press SELECT. Use the numerical keypad to enter new frequencies. Press
SELECT.
Press five times to move to the Modulation and Rolloff menu. Press SELECT.
7
Use
choose Rolloff. Press SELECT. Use
8
Press
RF frequency. Press SELECT. Press to move to the Sym. Rate menu. Press
SELECT. Enter the symbol rate. Press SELECT. If DVB-S2 is used, proceed to
step 9. If DVB-S is used, press to set up the FEC. Press SELECT. Use
select AUTO. Press SELECT.
9
Press
SELECT. Enter the value. Press SELECT.
10 Press . Press SELECT. Use
RF1 port is capable of providing 13V or 18V. Press SELECT.
11 Press MENU three times. Press to move to Save & Exit. Press SELECT. Save &
Exit will return you to the Main: Setup menu; Abandon & Exit will go back to the
last menu accessed with the original parameters; Cancel will go back to the last
menu accessed with changes saved.
12 The transcoder will search for the signal and display "Acquisition Successful." It
will find the first available channel on the network. Press MENU twice to return
to the start-up menu.
OL-31980 -01
to go to the Setup menu. Press SELECT. Press to move to the TS Input
to choose DVB-S or DVB-S2. Press SELECT. If DVB-S2 is used, press to
to move to the Freq., Sym Rate, and FEC menu. Press SELECT. Enter the
twice to move to the Net ID menu. Press
Quick Setup Instructions for RF Acquisition
to set the ASI port to Act (Activate). Press
to choose the value. Press SELECT.
to choose Net ID. Press
to change the LNB power, if needed. Only the
to set the RF1
to
13