Configuring The Dpm Mpegoip Output Details - Cisco D9859 Installation And Configuration Manual

Configuring Transport Stream Information
Viewing Stream Details
To view the stream details, click Stream Details in the MPEG over IP Output Main
or Stream page. The following Stream Status table is displayed.
The Stream Status table displays the status of the streams for the control and data
ports.
Viewing the MPEG over IP Output Status
The MOIP Output Status area (MPEG over IP Output Main and Stream pages)
displays the current output bit rates for the control port and data port (0 to 206
Mbps), the configured user rate, MPEG over IP TS overflow status, and whether
there are critical MPEG over IP engine errors.

Configuring the DPM MPEGoIP Output Details

Note: The following procedure defines all the available fields. For a typical setup of
the DPM, see Typical set up for Digital Program Mapping (DPM) (on page 210).
Note: After you make any changes, a successfully updated (session open) message
appears. The changes are displayed, but not saved. You must click Apply to save
and apply the changes.
OL-31980 -01 203