Cisco D9859 Installation And Configuration Manual page 220

Chapter 5 Web GUI Setup and Monitoring
Rate Control
Auto
User
3 In the User Rate field, enter the output user rate, which is only used if Rate
Control is set to User. If the output bit rate is less than the input, the output data
will be partially or completely lost.
Note: Output data will be partially lost if the user-selected bit rate is set to a
value that is less than the actual signal bit rate. This allows you to set the output
bit rate to a value expected by equipment connected to the MPEGoIP output.
You can enter a range from 0 to 206 Mbps.
4 From the Output Mode drop-down list, choose the DPM output mode. With the
exception of No Output and Full DPM Control, choosing a mode will configure
the DPM settings to achieve the specified behavior. In this way, they a ct as DPM
presets. The Mode Status is changed from Unmodified to Edited by User. It is
highly recommended to use either one of these basic modes, or, for advanced
setup, enter the DPM mapping before setting the Output Mode. The following
table describes each mode:
Output Mode
No Output
Passthrough
Service Channels
Only
MAP Passthrough
196
Description
The output rate follows that set by the uplink. This setting can be
used if the signal source is ASI. If Null Packet Insertion is set to
Yes, the output bit rate is the same as the input rate (including all
the null packets). If Null Packet Insertion is set to No, the output
rate is equal to the payload rate of the transport stream to be
encapsulated, and in most cases, it will be lower than the overall
input rate.
The output rate is specified by the User Rate field. It is determined
by the user setting regardless of the input source. Null packets are
always inserted when the configured output bit rate is higher than
the payload rate of the transport stream to be encapsulated.
Description
No MPEGoIP output will be generated.
All PEs will be set to Pass and other DPM settings will also be set.
Only service channels will be output.
The output will be identical to the input, except that channels
assigned to PEs and PIDs will be mapped using the DPM settings.
If the input is tuned to a valid channel, the PEs are automatically
set to Map. Otherwise, the PEs are automatically set to Drop.
Note: If the PE is mapped, it uses the last saved output MAP
configuration. The output map (for example, output channel PMT)
does not change automatically if the input or channel number is
changed.
OL-31980-01