Table of Contents
Advertisement
Teledyne LeCroy
3.2.5
Zoom In and Zoom Out
Click on the Zoom In button
zooming in and out. The buttons are shown in the screen capture below.
Note:
The Zoom In/Out buttons turn grey when the display is at maximum/minimum zoom.
Zoom In
Figure 3.5: Zoom In and Zoom Out Buttons
3.2.6
Overlay Signals Mode
Click on the Enable/Disable Overlay Signals Mode button
enabling and disabling the overlay signals mode. Overlay Signals mode allows you to take
a single signal and superimpose it on top of another signal, the top signal stays
translucent.
Figure 3.6: Enabling/Disabling Overlay Signals Mode
To overlay a signal, perform the following steps.
1. Click on the Enable/Disable Overlay Signals Mode button to activate it as shown in
2. Click on the signal to be overlaid, grab and move it as shown in the following screen
106
Zoom Out
Enable/Disable Overlay Signals Mode button.
When activated the button turns blue.
the screen capture above.
capture.
and the Zoom Out button
K ibra DDR Protocol Analyzer User Manual
Waveform View
to toggle between
to toggle between
Advertisement
Table of Contents
