Table of Contents
Advertisement
Teledyne LeCroy
5. Insert the DDR Slot 1 Interposer, and (if desired) DDR Slot 2 Interposer, into the HUT
6. For the Slot 1 Interposer, connect the ribbon cable to Slot 1 and the power cable to
IMPORTANT!
7. Turn on the host machine and the protocol analyzer. Open the DDR Protocol Suite.
8. Select Recording Options under Setup on the Menu Bar.
9. Select the General tab to display the factory default settings, such as Snapshot and
10. Select the DIMM Parameters and Violation Triggers tab. In the Memory Controller
11. The HUT can be turned on either now or after recording starts.
12. Click Start Recording
13. To terminate recording before the snapshot automatically completes, click Stop
14. When the recording session is finished, the traffic is automatically uploaded from
15. To save a current recording for future reference, select File > Save As, or click
16
DIMM‐socket slot(s) farthest from the CPU. Only one channel with up to two slots is
supported with a single Kibra DDR analyzer. Normally the DIMM connectors for two
slots in the same channel on a PC have the same color.
Interposer Power, both on the front of the protocol analyzer.
For the Slot 2 Interposer, connect the ribbon cable to Slot 2 on the front of the
protocol analyzer.
Please see the "Power on Procedure" on page 17 before performing step
7.
30‐MB buffer size. Use the default settings.
section, select the properties of the DIMM to analyze, including the DIMM Speed
and CAS Latencies. Uncheck the Timing Violation Trigger checkbox to cancel
triggers. Uncheck the Protocol Violation Trigger checkbox to cancel triggers. Click
OK to use the defaults for all other settings.
command, control, and address signals. After 30 MB of traffic are recorded, the
Analyzer uploads the data and displays the packets.
Recording
on the Tool Bar.
the Analyzer to the hard drive on your host machine as a file named data.ddrt (or
the name you assigned as the default filename). While the file is being uploaded,
you should see a progress bar at the bottom of the screen. When the bar
disappears, it indicates that the data has been uploaded to disk.
on the Tool Bar, to display the standard Save As screen. Give the recording a unique
name and save it to the appropriate directory.
on the Tool Bar. The system starts to capture DDR
Hardware Setup
Kibra DDR Protocol Analyzer User Manual
Advertisement
Table of Contents
