Table of Contents
Advertisement
Waveform View
Zooming with Viewport Slider
Figure 3.3: Zooming with Viewport Slider
3.2.3
Snap to Edge
If you have a marker or cursor and move it to within 10 pixels of a signal's edge, a glyph is
displayed showing that it will be dropped on that edge of the signal when dropped. You
need to hover over that particular signal with the mouse to see it. Snap to Edge is
sensitive in horizontal and vertical positions.
3.2.4
Placing Cursors
To place a pair of cursors activate the Cursor button as shown below and click the left
mouse button to place the left (x) cursor and then click the right mouse button to place
the right (y) cursor any where in the Waveform view. See the pink X1/Y1 and X2/Y2
cursors below.
Cursor Button
Figure 3.4: Placing Left and Right Cursors
K ibra DDR Protocol Analyzer User Manual
Press to activate placing cursor button
T eledyne LeCroy
Glyph showing signal edge
Left Cursor
Right Cursor
105
Advertisement
Table of Contents
