Preferences
The following options are available:
Note:
Preferences from version 1.20 and above should be usable/upgradable in future versions, but
those made with releases below 1.20 should be deleted as they are not forward compatible.
2.9.1
General
The General tab (see Figure 2.45 on page 74)allows you set the Time Stamp Reference.
The four options are:
Select an option and click Apply > Save.
K ibra DDR Protocol Analyzer User Manual
Listing View
Bank State View
RTS View
Save As.. ‐ Opens the Save Display Configuration File dialog to save the changes
made to the Preferences for future use. They can be saved in the default location
or you assign a name and save in a library.
Save as Default ‐ Click this button to restore the settings to the factory presets.
Load... ‐ Allows you to load the saved Preferences from the default location or
the library for the current session.
Restore Factory Settings ‐ Click this button to restore the settings to the factory
presets.
OK ‐ Saves the current Preferences.
Cancel ‐ Click this button to cancel any settings just made.
Apply ‐ Applies the changes made to the open trace file.
Synchronize All Views ‐ When selecting items makes them visible in all views.
Hide DES Commands ‐ This hides all DES and NOP commands from the view,
replacing them with a cross‐hatch pattern to indicate the time discontinuity.
Absolute ‐ Hardware Timestamp which can be synchronized with other analyzers
via CATC SYNC/CrossSync (refer to "CrossSync Control Panel" on page 71)
Relative To Start ‐ Assumes first sample = 0
Relative To Trigger Point ‐ Assumes trigger point is time = 0
T eledyne LeCroy
73