Teledyne LeCroy
3.4
Listing View
The Listing View for each captured signal can be viewed. The Listing View displays the
text‐based decode of commands in time order.
The Listing View is synchronized with the Waveform view and displays data in column
format.
Figure 3.35: Listing View
The following actions can be performed in the Listing View:
130
Combines all address pieces (RA, CA, BA, CS) into full physical address.
User should define mapping of address lines
The row and column address are dependent on the DRAM density and data
width defined in the Recording Options.
Markers are inserted for adding user defined comments within the Listing View.
The listing view shows a listing of each clock cycle on the bus called a "sample".
Left clicking anywhere on a row enables selection of that command. The primary
marker is indicated by a line just below the selected row. Also, by selecting this
sample, the primary "selection" marker is updated on both the waveform and
state view screens to this selection point.
There is no ZOOM function inside the Listing view.
The scroll wheel operation inside the listing view will scroll the traffic up or
down.
Protocol and Timing violations are shown at the timestamp where they occur.
The comments field not only decodes the commands, but also decodes full MRS
commands.
K ibra DDR Protocol Analyzer User Manual
Listing View