Table of Contents
Advertisement
Teledyne LeCroy
2.6.1
Recording Options - General Tab
The following settings can be set from the General tab. The options on the General tab
are explained below.
Product
Select a product for the recording options from either Kibra 380 Protocol Analyzer or
Kibra 480 Protocol Analyzer.
Recording Type: Trigger Mode
The Trigger Recording Options dialog allows you to specify when the analyzer completes
a data capture. Three trigger modes are available: The default Snapshot, Manual Trigger,
and Event Trigger.
When data capture starts with Snapshot selected, the analyzer triggers on the first data
pattern on the bus.
Starting a data capture with Event selected triggers when specific event(s) are detected in
the captured data stream. The following three ways can trigger the analyzer with Event
selected:
Figure 2.7: Trigger Setup
Snapshot Mode
To capture immediately on any trace, check the Snapshot button.
Manual Trigger Mode
In the Manual Trigger mode, the analyzer captures bus traffic continually from when you
use the Start button until you click the Manual Trigger button (on the analyzer toolbar),
which triggers the analyzer. To perform a manual trigger, click the Manual Trigger button.
This selection also enables the External SMA Trigger function.
38
Trigger on Specific DDR3 or DDR4 Commands
Trigger on DDR3 or DDR4 Protocol or Timing Violations
External Trigger‐in (from other test equipment)
Recording Options Setup
K ibra DDR Protocol Analyzer User Manual
Advertisement
Table of Contents
