GE akta start Maintenance Manual page 19

Installing and moving the
instrument
ÄKTA start Maintenance Manual 29-0603-08 AC
WARNING
To avoid damage to person when installing or moving ÄKTA start,
follow the instructions below.
•
Moving the instrument horizontally. One person is recommend-
ed when moving the instrument horizontally.
•
Supply voltage. Make sure that the supply voltage at the wall
outlet corresponds to the marking on the instrument, before
connecting the power cord.
•
Power cord. Only use grounded power cords delivered or ap-
proved by GE.
•
Access to power switch and power cord with plug. Do not
block access to the power switch and power cord. The power
switch must always be easy to access. The power cord with
plug must always be easy to disconnect.
•
Installing the computer (optional). The computer should be
installed and used according to the instructions provided by
the manufacturer of the computer.
•
Disconnect power. Always switch off power to ÄKTA start be-
fore an instrument module is removed or installed, or a cable
is connected or disconnected.
CAUTION
To avoid damage to person when installing or moving ÄKTA start,
follow the instructions below.
Protective ground. ÄKTA start must always be connected to a
grounded power outlet.
2 Safety instructions
2.1 Safety precautions
19