System - GE akta start Maintenance Manual

5 Service and settings

5.14 System

5.14 System

Introduction
This section describes how to handle firmware updates and export system reports. It
also describes how to set delay volumes and switch valve timing.
In this section
This section contains the following subsections:
Section
5.14.1 Firmware update
5.14.2 Export system report to USB
5.14.3 Delay volume setting
5.14.4 Switch valve timing
Parameter descriptions
Parameter
Delay volume setting
Firmware update
FPGA update
118
Description
The delay volume represents the volume of liquid
found in the flow path between the outlet of the
UV Monitor and the collection tubes. This option
is used to set the delay volume (ml).
This option is used to update the firmware version
of the instrument whenever a new firmware is
available on the ÄKTA start product support page,
refer to www.gelifesciences.com/AKTA.
ÄKTA start has a dedicated digital drive mecha-
nism to improve the life of modules. This is con-
trolled by a digital logic and the firmware can be
updated in the field by selecting FPGA update.
The required updating files can be downloaded
from the ÄKTA start product support page, refer
to www.gelifesciences.com/AKTA.
ÄKTA start Maintenance Manual 29-0603-08 AC
See page
120
123
124
125