Conductivity Monitor - GE akta start Maintenance Manual

7 Disassembly

7.10 Conductivity Monitor

7.10 Conductivity Monitor

Required tools
Tool
Torx screwdriver
Instructions
Follow the instructions below to remove and replace the Conductivity Monitor.
Note:
Step
1
2
182
WARNING
Disconnect power. Always switch off power to the instrument be-
fore replacing any component on the instrument or cleaning the
instrument, unless stated otherwise in the user documentation.
If required, twist the connector to bring the connector out of the instrument
hole, before disassembly the Conductivity Monitor.
Action
Switch off the instrument by pressing the Power Switch to the O position.
Remove the inlet and outlet tubing from the ports.
Dimension
T20
ÄKTA start Maintenance Manual 29-0603-08 AC