Fcc Statement - GE akta start Maintenance Manual

FCC statement

ÄKTA start complies with FCC 47 CFR Part 15b.
Note:
Regulatory compliance of
connected equipment
Any equipment connected to ÄKTA start should meet the safety requirements of EN
61010-1/IEC 61010-1, or relevant harmonized standards. Within EU, connected equipment
must be CE marked.
Environmental Conformity
Requirement
2011/65/EU
2012/19/EU
ACPEIP
ÄKTA start Maintenance Manual 29-0603-08 AC
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Description
Restriction of Hazardous Substances (RoHS) Directive
Waste Electrical and Electronic Equipment (WEEE) Directive
Administration on the Control of Pollution Caused by Electronic In-
formation Products, China Restriction of Hazardous Substances
(RoHS)
1 Introduction
1.3 Regulatory information
11