Serial Interfaces - Siemens siprotec 7SA522 User Manual

4.14

Serial Interfaces

7SA522 Manual
C53000-G1176-C119-2
Devices in the SIPROTEC
q
The operating interface is used for on-site connection of a PC, on which DIGSI
is installed. All operations that are possible using DIGSI
terface.
q
The service interface on the back panel is for connection to remote diagnostic facil-
®
ities, e.g. DIGSI 4 via modem and/or a star connection. All DIGSI
are possible via this interface.
q
The system interface on the back panel of the device is used for connection to a
central master control system, such as SICAM SC.
q
The time control interface on the back panel of the device is used for time synchro-
nization (e.g. IRIG B, DCF77).
®
In the DIGSI 4 interface settings window (under "Serial Ports") there are, among oth-
er items, settings for:
− transmission protocols and
− transmission speeds.
Note:
The system interface can be equipped with different modules for connection to other
devices via optical fibres, RS485 (EIA485) bus or RS232 interface.
®
4 family can be equipped with up to four serial interfaces.
®
SIPROTEC 4 Devices
®
®
4 can be done at this in-
®
4 operations
4-31
4