7XV75 Test Switch
Notes on Safety
This catalogue contains notes that must be adhered to for your own personal safety and to avoid damage to property.
However, it does not constitute a complete description of all safety measures required for installation, service, and mainte-
nance of the equipment (module, device) in question. Details are to be taken from the device manual and those are manda-
tory.
WARNING
Danger of severe personal injury or substantial damage to property
Hazardous voltages may occur in devices and modules during operation depending on the design and appli-
cation.
Always observe the instructions given in "Qualified Electrical Engineering Personnel" below.
Qualified Electrical Engineering Personnel
Only qualified electrical engineering personnel may commission and operate the equipment (module, device) described in
this document. Qualified electrical engineering personnel in the sense of this document are people who can demonstrate
technical qualifications as electrical technicians. These persons may commission, isolate, ground and label devices, sys-
tems and circuits according to the standards of safety engineering.
Use as Prescribed
The equipment (device, module) may only be used for such applications as set out in the catalogs and the technical de-
scription, and only in combination with third-party equipment recommended and approved by Siemens.
Problem-free and safe operation of the product depends on the following:
•
Proper transport
•
Proper operation and maintenance
•
Proper storage, setup, and installation
WARNING
Danger of death, personal injury or substantial property damage
Non-observance of the following measures can result in death, personal injury or substantial property
damage.
The equipment must be grounded at the grounding terminal before any connections are made.
If you require further information, or if particular problems occur that are not handled in sufficient depth in the instructions
of the respective product, you can request help through your local Siemens Office or representative.
Statement of Conformity
Low-voltage Directive 2014/35/EU
RoHS Directive 2011/65/EU R
The conformity is based on the compliance with
the following harmonized standards
EN 50581 and EN 60255-27
Further standards
IEC 60255, VDE 0435
1
7XV75 Test Switch
Siemens AG
March 2021