Siemens siprotec 7SA522 User Manual page 424

Control During Operation
7-16
• 3ULPDU\ with
2SHUDWLRQDO PHDVXUHG YDOXHV SULPDU\,
3ULPDU\ RSHUDWLQJ LPSHGDQFH;
6\QFKURFKHFN PHDVXUHG YDOXHV SULPDU\
• 6HFRQGDU\ with
2SHUDWLRQDO PHDVXUHG YDOXHV VHFRQGDU\,
6HFRQGDU\ RSHUDWLQJ LPSHGDQFH;
• 3HUFHQWDJH with
2SHUDWLRQDO PHDVXUHG YDOXHV SHUFHQWDJH,
referred to the rated operational values;
• 2WKHU with
8VHU GHILQHG PHDVXUHG YDOXHV,
8VHU GHILQHG FRXQWHU,
6HW SRLQW YDOXH RI PHDVXUHG YDOXH,
i.o.w. only such values that were generated in the configuration (according to 5.2)
and/or with the user definable logic CFC (according to Section 5.3).
If a measured value is not available, then instead of the measured value, 3 dots ap-
pear. If the value is undefined (e.g., cos ϕ, when no current is flowing), then "–––" ap-
pears (3 horizontal bars). If the measured value overruns, then "
are displayed.
Double click on the desired measure value group; e.g. 3ULPDU\ 9DOXHV. The next
sub-group is displayed.
Double click on the desired sub-group; e.g. 2SHUDWLRQDO YDOXHV SULPDU\.
By double clicking on an entry in the list on the right side of the window, the associated
contents of the measured value group are displayed in another window, as shown in
Figure 7-19.
Figure 7-19 Example of measured values shown in DIGSI

" (3 asterisks)
®
4
7SA522 Manual
C53000-G1176-C119-2