wsm RTV-X1120D Workshop Manual page 77

RTV-X900, RTV-X1120D, WSM
Replacing Slow-Blow Fuses
The slow-blow fuses are intended to protect the electrical
cabling. If any of them have blown out, be sure to pinpoint the
cause. Never use any substitute, use only a KUBOTA genuine part.
 Replacement procedure
1. Disconnect the negative cable of the battery.
2. Open the seats and remove the utility box and maintenance
cover.
3. Remove the fuse box cover.
4. Pull out the slow-blow fuse.
5. Insert a new slow-blow fuse into the slow-blow fuse box.
6. Install the slow-blow fuse box cover and the maintenance cover.
7. Connect the negative battery cable.
Replacing Light Bulb
1. Head light and turn signal light (front)
Take the bulb out of the light body and replace it with a new one.
2. Other lights
Detach the lens and replace the bulb.
Light
Head light (Clear type)
Tail light
Brake light
Turn signal light (front)
Turn signal light (rear)
Work light (front)
Work light (rear)
Checking Hydraulic Tank Suction Strainer
1. Make sure that the hydraulic tank is not damaged and the oil
does not leak out of the hydraulic tank.
2. Make sure that the water is not mixed with the oil.
3. When the suction strainer is dirty, wash it with the light oil.
(1) Hydraulic Tank
G-56
GENERAL
9Y1210946GEG0077US0
Capacity
37.5 W
5 W
21 W
21 W (if equipped)
21 W (if equipped)
35 W (if equipped)
27 W (if equipped)
9Y1210946GEG0078US0
(2) Suction Strainer
9Y1210946GEG0079US0
KiSC issued 01, 2014 A