wsm RTV-X1120D Workshop Manual page 271

RTV-X900, RTV-X1120D, WSM
Draining Coolant
WARNING
To avoid serious injury:
• Do not remove the radiator cap while coolant is hot. When
cool, slowly rotate cap to the first stop and allow sufficient
time for excess pressure to escape before removing the
cap completely.
IMPORTANT
• Do not start engine without coolant.
• Do not remove the cap on the radiator.
• Use clean, fresh distilled water and anti-freeze to fill the
radiator and recovery tank.
• When the anti-freeze is mixed with distilled water, the
antifreeze mixing ratio is 50 %.
• Securely tighten radiator cap. If the cap is loose or
improperly fitted, water may leak out and the engine could
overheat.
• Make sure that the engine coolant breather is closed, after
filling the coolant.
1. Stop the engine and let cool down.
2. Open the hood.
3. To drain the coolant, remove the radiator cap (3), open the
engine coolant breather (5), and remove the radiator drain plugs
(1). The radiator cap must be removed to completely drain the
coolant.
4. After all coolant is drained, close the drain plug.
Radiator with
recovery tank Capacity
(Coolant)
(1) Drain Plug
(2) Front Skid Plate
(3) Radiator Cap
(4) Recovery Tank
(5) Engine Coolant Breather
2-S24
TRANSMISSION
6.1 L
6.4 U.S.qts
5.4 Imp.qts
A: FULL
B: LOW
9Y1210946ENS0026US0
KiSC issued 01, 2014 A