wsm RTV-X1120D Workshop Manual page 395

RTV-X900, RTV-X1120D, WSM
Power Steering Cylinder
1. Carefully clamp the cylinder in a vise.
2. Push one of the guide assembly (3) to inside of cylinder tube (2).
3. Drill a hole (2.5 mm dia., 0.1 in. dia.) on the cylinder tube (2) just
over the snap ring (4) as shown figure left.
4. Take a little screwdriver and lift off the snap ring (4) from its
groove. Simultaneousness support this action by pushing from
the outside of the cylinder tube with another little screwdriver or
another tool.
5. Push out the piston rod assembly (9) and take off the guide
assembly (3).
(When reassembling)
NOTE
• Seals must be exchanged after disassembling.
• Apply transmission fluid to the exchanged seals.
• Enter the piston rod and block the guide assemblies with
the snap rings.
(1) Piston Rod
(2) Cylinder Tube
(3) Guide Assembly
(4) Snap Ring
(5) Guide
(6) Seal Ring
(7) Wiper Seal
6-S15
STEERING
(8) O-ring
(9) Piston Rod Assembly
(10) Center Piston
A: Drill a Hole
B: 5.25 mm (0.267 in.)
L: 338 mm (13.3 in.)
9Y1210946STS0016US0
KiSC issued 01, 2014 A