wsm RTV-X1120D Workshop Manual page 333

RTV-X900, RTV-X1120D, WSM
Tie-rod End, Brake Hose and Breather Hose
CAUTION
• When the brake hose is removed, the brake fluid come out.
Be careful not to stain other hoses or rubber boot with the
brake fluid.
Brake fluid stains should be washed and wiped off
immediately. Likewise, the brake fluid on the tools should
be wiped off immediately.
1. Remove the clamp (2).
2. Remove the eye joint bolt (5) for brake hose (6) and drain the
brake fluid.
3. Remove the breather pipe (1).
4. Remove the cotter pin (7) and remove the tie-rod end slotted nut
(4).
(When resembling)
• Replace the copper washers with new ones.
• Bleed air of the brake line after break hoses reassembled.
• Tighten the slotted nut to 50.0 N·m (5.10 kgf·m, 36.9 lbf·ft). If the
slot and pin hole do not meet, tighten the nut until they do meet,
and install cotter pin.
Tie-rod end slotted nut
Tightening torque
Brake hose eye joint bolt
(M10)
(1) Breather Pipe
(2) Clamp
(3) Tie-rod End
(4) Tie-rod Slotted Nut
4-S10
BRAKES
50.0 to 55.0 N·m
5.10 to 5.60 kgf·m
36.9 to 40.5 lbf·ft
22.6 to 26.8 N·m
2.31 to 2.73 kgf·m
16.7 to 19.7 lbf·ft
(5) Eye Joint Bolt
(6) Brake Hose
(7) Cotter Pin
9Y1210946FAS0009US0
KiSC issued 01, 2014 A