wsm RTV-X1120D Workshop Manual page 147

RTV-X900, RTV-X1120D, WSM
Wiring Harness LH
1. Disconnect the starter connectors (3).
2. Disconnect the engine oil pressure switch connector (2).
3. Disconnect the ground cables (4).
4. Disconnect the alternator connectors (1).
5. Disconnect the thermometer switch connector (5).
6. Disconnect the speed sensor connector (6).
7. Disconnect the safety switch connector (7).
(1) Alternator Connector
(2) Engine Oil Pressure Switch
Connector
(3) Starter Connector
Wiring Harness RH and Speed Control Panel Cable
1. Disconnect the glow connector (1).
2. Disconnect the thermo sensor connector (2).
3. Disconnect the engine stop solenoid connector (4).
4. Disconnect the speed control pedal cable (3).
(When reassembling)
• Adjust the length of speed control pedal cable. (See page
2-S14.)
(1) Glow Connector
(2) Thermo Sensor Connector
1-S38
ENGINE
(4) Ground Cable
(5) Thermometer Switch Connector
(6) Speed Sensor Connector
(7) Safety Switch Connector
9Y1210946ENS0046US0
(3) Speed Control Pedal Cable
(4) Engine Stop Solenoid Connector
9Y1210946ENS0047US0
KiSC issued 01, 2014 A