wsm RTV-X1120D Workshop Manual page 332

RTV-X900, RTV-X1120D, WSM
Front Wheel and Front Axle Nut
WARNING
To avoid serious injury, death or vehicle damage:
• Do not work under the vehicle unless it is secured by safe
stands or suitable blocking.
1. Jack up at the plate under the front axle case only.
2. Remove the cotter pin (2) and just loosen the slotted nut (3) for
drive shaft.
3. Remove the front wheel mounting screw.
(When reassembling)
• After tightening the front axle slotted nut to specified torques,
install a cotter pin as shown in the figure left.
NOTE
• Tighten the slotted nut to 190 N·m (19.4 kgf·m, 140 lbf·ft). If
the slot and pin hole do not meet, tighten the nut until they
do meet, and install cotter pin.
Front axle slotted nut
Front wheel mounting bolt
Tightening torque
and nut (Aluminum wheel)
Front wheel mounting bolt
and nut (Steel wheel)
(1) Front Wheel
(2) Cotter Pin
4-S9
BRAKES
190 to 200 N·m
19.4 to 20.3 kgf·m
141 to 147 lbf·ft
90 to 110 N·m
9.2 to 11.2 kgf·m
66.4 to 81.1 lbf·ft
108 to 130 N·m
11.1 to 13.2 kgf·m
79.7 to 95.8 lbf·ft
(3) Slotted Nut
9Y1210946FAS0008US0
KiSC issued 01, 2014 A