wsm RTV-X1120D Workshop Manual page 40

RTV-X900, RTV-X1120D, WSM
Checking Hydraulic Oil Tank Level
1. Park the vehicle on a level surface.
2. Stop the engine.
3. Open the seat and remove the utility box.
4. Remove the rubber cap.
5. To check the oil level, remove the dipstick, wipe it clean, screw
it into filling hole and remove dipstick again.
If the level is too low, add new oil to the prescribed level at the
oil inlet.
(Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-8.)
IMPORTANT
• If oil level is low, do not run engine.
(1) Filling Plug with Dipstick
Checking Coolant Level
WARNING
To avoid serious injury:
• Do not remove radiator cap while coolant is hot. When cool,
slowly rotate cap to the first stop and allow sufficient time
for excess pressure to escape before removing the cap
completely.
1. Park the vehicle on a level surface.
2. Stop the engine.
3. Open the hood.
4. Check to see that the coolant level is between the "FULL" and
"LOW" marks of recovery tank.
5. When the coolant level drops due to evaporation, add water
only up to the full level.
In case of leakage, add anti-freeze and water in the specified
mixing ratio up to the full level.
(Refer to "4. LUBRICANTS, FUEL AND COOLANT" on page
G-8.)
IMPORTANT
• If the radiator cap has to be removed, follow the caution
above and securely retighten the cap.
• Use clean, fresh water and anti-freeze to fill the recovery
tank.
(1) Radiator Cap
(2) Recovery Tank
Cleaning Radiator Screen
WARNING
To avoid serious injury:
• Be sure to stop the engine before removing the screen.
1. Park the vehicle on a flat surface.
2. Stop the engine.
3. Open the hood.
4. Detach the screen and remove all foreign materials.
IMPORTANT
• Radiator screen must be clean from debris to prevent
engine from overheating.
(1) Radiator Screen
G-19
GENERAL
A: Oil level is acceptable within this
range.
9Y1210946GEG0012US0
A: FULL
B: LOW
9Y1210946GEG0013US0
A: DETACH
9Y1210946GEG0014US0
KiSC issued 01, 2014 A