wsm RTV-X1120D Workshop Manual page 153

RTV-X900, RTV-X1120D, WSM
Nozzle Heat Seal Service Removal Procedure
IMPORTANT
• Use a plus (phillips head) screw driver (1) that has a
diameter which is bigger than the heat seal hole (Approx.
6.0 mm (0.24 in.)).
1. Drive screw driver (1) lightly into the heat seal hole.
2. Turn screw driver three or four times each way.
3. While turning the screw driver, slowly pull the heat seal (4) out
together with the injection nozzle gasket (3).
4. If the heat seal drops, repeat the above procedure.
(When reassembling)
• Heat seal and injection nozzle gasket must be changed when
the injection nozzle is removed for cleaning or for service.
(1) Plus Screw Driver
(2) Injection Nozzle
Rocker Arm and Push Rod
1. Remove the rocker arm bracket screws (2).
2. Remove the rocker arm assembly (1).
3. Remove the push rods (3).
(When reassembling)
• When putting the push rods (3) onto the tappets (4), check to
see if their ends are properly engaged with the dimples.
IMPORTANT
• After installing the rocker arm, be sure to adjust the valve
clearance.
Tightening torque Rocker arm bracket screw
(1) Rocker Arm Assembly
(2) Rocker Arm Bracket Screws
1-S44
ENGINE
(3) Injection Nozzle Gasket
(4) Heat Seal
9Y1210946ENS0056US0
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(3) Push Rod
(4) Tappet
9Y1210946ENS0057US0
KiSC issued 01, 2014 A