wsm RTV-X1120D Workshop Manual page 262

RTV-X900, RTV-X1120D, WSM
Checking Range Gear Shift Lever Position (Adjusting of the
Shift Cable Length and the Select Cable Length)
CAUTION
• When checking, park the machine on flat ground, and apply
the parking brake.
• Work by 2 people when you checking and adjusting range
gear shift lever position.
1. Place the stand under the left side of under frame by jack.
2. Remove the rear skid plate (1).
3. Remove the rear wheel LH.
4. Remove the range gear shift cable (2) from the range gear shift
arm (5).
5. Remove the range gear shift cable (2) from the range gear shift
lever (6).
6. Adjust the range gear shift arm (5) to the neutral position, where
the range gear shift arm (5) position to the position neutral
position.
7. Set the range gear shift lever (6) position to the neutral position.
8. When installing the range gear shift cable (2) to the cable stay
(5), set the adjusting screw at the center position.
9. Install the range gear shift cable (2) to the range gear shift arm
(5).
10. Make sure that the range gear shift lever (6) is set at the natural
position and install the range gear shift cable (2) to the lever
support.
11. Move the range gear shift lever (6) from "L" to "H", "N" and "R"
and make sure that the range gear shift arm (5) moves smoothly
into detent positions.
12. Make sure that the lock nut (3) of the range gear shift cable (2)
is surely fastened.
13. Also check that the lock nuts (3) at the cable end and the ball
joint are not loose. Check that the ball joint fitting nuts (lever side
and arm side) are tightened.
(1) Rear Skid Plate
(2) Range Gear Shift Cable
(3) Lock Nut
(4) Lock Nut
(5) Range Gear Shift Arm
(6) Range Gear Shift Lever
2-S15
TRANSMISSION
A: Adjust the nuts.
B: Center of Tread
N: Neutral Position
9Y1210946TRS0013US0
KiSC issued 01, 2014 A