wsm RTV-X1120D Workshop Manual page 261

RTV-X900, RTV-X1120D, WSM
Checking Speed Control Pedal Stroke (Adjustment of the
Speed Control Pedal Cable)
CAUTION
• When checking, park the machine on flat ground, apply the
parking brake.
• Work by two people when you checking and adjusting
speed control pedal stroke.
1. Mount the speed control pedal cable (3) on the bracket (2) and
adjust until the speed control pedal (1) is in contact with the
bracket (2).
2. Set the stopper bolt to a position where it is in contact with the
speed control pedal (1) with the speed control pedal (1) pushed
all the way down.
3. Then, loosen the stopper bolt (5) a half turn and fix in place with
a lock nut.
4. Start the engine and check engine speed.
5. If the engine speed is outside of factory specifications, adjust
the speed using the HST control rod and the engine cable.
NOTE
• Speed control pedal cable (3) adjustment is performed
through adjustment of the HST control rod and engine
cable.
Condition
• Engine speed:
(RTV-X900) 1350 min
(RTV-X1120D) 1400 min
• Engine maximum speed:
(RTV-X900) 3320 to 3420 min
(RTV-X1120D) 3070 to 3170 min
(1) Speed Control Pedal
(2) Bracket
(3) Speed Control Pedal Cable
(4) HST Linkage
(5) Stopper Bolt
2-S14
TRANSMISSION
-1
(rpm)
-1
(rpm)
-1
(rpm)
-1
(rpm)
A: Center of thread
B: Adjust the nuts.
9Y1210946TRS0012US0
KiSC issued 01, 2014 A