wsm RTV-X1120D Workshop Manual page 267

RTV-X900, RTV-X1120D, WSM
Draining Hydraulic Tank Oil
WARNING
To avoid personal injury:
• Be sure to stop the engine before changing the oil
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Park the vehicle on a level surface.
2. Open the seat and remove the utility box.
3. Remove the rubber cap.
4. To drain the used oil, remove the drain plug (1) and filling plug
(2) plug and drain the oil completely into the oil pan.
5. After draining, reinstall the drain plug.
(When reassembling)
• Fill with new KUBOTA SUPER UDT fluid up to the upper notch
on the dipstick.
How to check:
Wipe dipstick clean a rag and screw it into filling hole. Remove
dipstick again to see if the oil level is between the upper and
lower notch.
• After filling, reinstall the filling plug.
Hydraulic tank oil Capacity
(1) Drain Plug
(2) Filling Plug with Dipstick
Transmission Rear Cover
1. Remove the transmission rear cover (1).
(1) Transmission Rear Cover
Unload Cable Linkage
1. Disconnect the oil temperature switch connector (1).
2. Remove the unload cable linkage (2) with unload cable.
(When reassembling)
• Adjust the unload cable. (See page 2-S18.)
(1) Oil Temperature Switch Connector (2) Unload Cable Linkage
2-S20
TRANSMISSION
18.0 L
19.0 U.S.qts
15.8 Imp.qts
A: Oil level is acceptable within this
range.
9Y1210946ENS0027US0
9Y1210946ENS0041US0
9Y1210946ENS0037US0
KiSC issued 01, 2014 A