wsm RTV-X1120D Workshop Manual page 265

RTV-X900, RTV-X1120D, WSM
Checking VHT Pressure Release Cable (Unload Cable)
1. Check the unload cable (1) connect the brake pedal as shown
is figure.
2. Move the arm (4) and spool (5) from side to side by hand and
check a play.
3. If the play "A" is not from 0 to 1 mm (0 to 0.04 in.), adjust the
unload cable (1) with a lock nuts.
4. When you fix the lock nuts, fix the backward lock nut (3) first,
and then tighten the front lock nut (2).
5. Then, press the brake pedal, and check if the arm (4) pushes
the spool (5).
6. When the arm (4) pushes the spool (5), check what the length is.
7. If the length which the spool (5) was pushed is not enough,
adjust the play "A" with a lock nut again.
Play "A" Reference
Length "B" Reference
(1) Unload Cable
(2) Front Lock Nut
(3) Backward Lock Nut
2-S18
TRANSMISSION
0 to 1 mm
0 to 0.04 in.
17.5 mm
0.689 in.
(4) Arm
(5) Spool
9Y1210946TRS0016US0
KiSC issued 01, 2014 A